Wall Spacers; Installing The Refrigeration Appliance - Miele KFN 4374 ED ws Operating Instructions Manual

Wall spacers

The wall spacers  on the back of
your refrigeration appliance ensure
that moisture can be diverted away
from the appliance appropriately.
If the wall spacers are not used, the
depth of the refrigeration appliance
will decrease by approx. 22 mm.

Risk of damage due to high
levels of moisture at the back of the
appliance.
Removing the wall spacers can result
in increased moisture levels at the
back of the appliance.
Do not remove the wall spacers from
the back of the appliance.
The refrigeration appliance does not
require wall spacing at the side. All
drawers and shelves can still be pulled
out.
Installing the refrigeration ap-
pliance

Risk of injury and damage due to
the refrigeration appliance tipping
over.
There is an increased risk of injury
and damage if the refrigeration appli-
ance is installed by a single person.
Two people are required for installing
the refrigeration appliance.

Risk of damage to the appliance
door caused by impact.
The appliance door could hit the wall
of the room resulting in damage to
the door.
Protect the appliance door by fitting
a felt stopper, for example, to the
wall of the room.

Risk of damaging the floor.
Moving the refrigeration appliance
can cause damage to the floor.
Move the refrigeration appliance
carefully on floors that are sensitive
to scratching.
Tip: The refrigeration appliance must be
empty when it is installed.
 Prepare the refrigeration appliance for
installation as close as possible to its
intended installation site.
 Connect the refrigeration appliance to
the electricity supply as described in
"Electrical connection".
 Move the refrigeration appliance
carefully to its intended installation
site.
Installation
19