Table of Contents
Advertisement
The machine doors can be aligned with
the machine casing after they have
been fitted.
In the following illustration, the ma-
chine door is not shown in the closed
position to make it easier to see what
you have to do.
To align the lower machine door, use
the outer slots in the lower hinge plate:
Remove the middle screw from the
hinge plate.
Slightly loosen both outer screws .
Align the machine door by sliding the
hinge plate to the left or right.
Then, tighten the screws . The
screw does not need to be refitted.
Aligning the machine doors
To align the upper machine door, use
the outer slots in the middle hinge plate:
Slightly loosen both screws .
Align the machine door by sliding the
hinge plate to the left or right.
Then, tighten the screws .
95
Advertisement
Table of Contents
