Connecting The Mxa-8400 - Lyngdorf Audio MXA-8400 Owner's Manual

Connecting the MXA-8400

1. Switch off and disconnect the MXA-8400 from mains power.
2. Set the SENSITIVITY switch, POWER STATE switch, and BRIDGE MODE switch accordingly, matching your
system.
3. Connect each analog audio output channel from the external pre-amp or processor to the intended
balanced XLR input on the MXA-8400.
4. Connect each loudspeaker to the intended speaker output channel on the MXA-8400 by inserting the
wired Neutrik speakON connector to the Neutrik socket on the back. Lock the connection with a short
twist to the right side until you hear and feel a click.
To disconnect a Neutrik speakON connector, pull back its metal grip and unlock the connector with a short
twist to the left side.
5. Connect the MXA-8400 to mains power.
6. Switch on the external pre-amp or processor first.
7. Switch on the MXA-8400 using the power switch on the back.
The MXA-8400 is ready for operation.
8. Adjust the pre-amp's or processor's volume control according to the desired level, and start playing from
the sound source.
Lyngdorf Audio MXA-8400 – Owner's manual 16