Setting Up The Mxa-8400 - Lyngdorf Audio MXA-8400 Owner's Manual

Setting up the MXA-8400

Speaker outputs
Connect each loudspeaker to the intended MXA-8400 speaker socket 1 - 8, using the provided
Neutrik speakON NL4 connectors.
Always turn off the MXA-8400 and other components in the system before connecting or
disconnecting loudspeakers.
Every output has the same performance specifications and provides the same sound quality.
Outputs 5 - 8 have an inverted configuration internally, compared to outputs 1 - 4. This is to utilize the power
supply to the best possible extent and to ensure equal power conditions for all channels. This configuration
does not affect the XLR input connections nor speaker output connections. All amplifier channels must be
connected in the same way.
Mains switch and mains connector
Be sure that the power cable plug is inserted firmly in the connector inlet. If you intend not to use
the amplifier for long periods of time, for example during vacation, switch off the mains switch.
SERVICE network port
This port is only intended to be used by Lyngdorf Audio for service purposes.
SENSITIVITY switch
The MXA-8400 can be set to match the output voltage of your pre-amp or processor.
Please refer to the technical specifications or owner's manual of the pre-amp or
processor to verify its output voltage, or contact the manufacturer.
•
Set switch to HIGH to match an input voltage around 2V
•
Set switch to LOW to match an input voltage around 6V
Lyngdorf Audio MXA-8400 – Owner's manual 11