Keypad Models - DSC neo HS128 E User Manual

Chapter 2.0 Understanding Your Keypad
11. Chime
12. OPEN
13. AC
14. System Trouble
15. Night
16. Ready Light (green)
17. Set Light (red)

2.2 Keypad Models

Note: In the following list if x = 8 (the system operates in 868MHz band).
HS2LCD Alphanumeric LCD keypad
HS2LCDP Alphanumeric LCD keypad with Prox. Tag support
HS2ICN Icon keypad
Icon keypad with Prox. Tag support
HS2ICNP
LED keypad
HS2LED
HS2LCDRFx Alphanumeric LCD keypad with wireless receiver
HS2LCDRFPx Alphanumeric LCD keypad with wireless receiver and Prox. tag support
HS2ICNRFx Icon keypad with wireless receiver
HS2ICNRFPx Icon keypad with wireless receiver and Prox. tag support
Wireless Alphanumeric LCD keypad
HS2LCDWFx
Wireless Alphanumeric LCD keypad with Prox. Tag support
HS2LCDWFPx
HS2LCDWFPVx Wireless Alphanumeric LCD keypad with Prox. Tag support & Voice Promp
HS2TCHP Touchscreen keypad. For additional information, refer to the HS2TCHP
Touchscreen User Manual.
Note: For systems compliant with EN50131-1 and EN50131-3 the HS2LED keypad shall be used in
conjunction with an LCD type keypad (HS2LCD(P) or HS2LCDRF(P)8 or HS2LCDWF(P)8 in
order to be able to review logged events and also to allow overriding of conditions that inhibit set-
ting of the alarm system. The HS2LED keypad alone cannot support these functions.
This icon turns on when the Chime function key is pressed to
enable Door Chime on the system. It will turn off when the chime
function key is pressed again to disable Door Chime.
This icon is used with clock digits 1 and 2 to indicate activated
zones (not alarm) on the system. When zones are opened, the
OPEN icon will turn on, and 7 segment displays 1 and 2 will scroll
through the violated zones.
Indicates that AC is present at the main panel.
Indicates that a system trouble is active.
Indicates that the panel is set in the Night Mode.
If the Ready light is on, the system is ready for setting. If the
toggle of the Ready LED flashes for Force Setting enabled, the
LED flashes with force setable zones open on the partition.
If the Set light is on, the system has been set successfully.
- 6 -