Table of Contents
Advertisement
Combined Systems
2-3
Combined Systems
Example 1: C500 Master
and C200H Slaves
C-Series
PC other
than the
C200H
C500 Master
Caution
!
16
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Individual sections of cable must not be longer than 2 m. Each extra Expan-
sion I/O Rack must be counted as a 'Slave' when computing the number of
Slaves controlled by the PC.
C200H Master
C200H PC
Slave Rack
I/O Con-
necting
Cable
Expansion I/O Rack
C500 and C200H Remote I/O Units can be combined into the same System.
That is, C500 Slaves can be connected to C200H Masters; C200H Slaves, to
C500 Masters.
The maximum number of connectable Units is the same as in any Remote
I/O System based on the C500-RM201 (see 2-1 Basic System ). Word
assignments will be based on the C500 PC, i.e., based on the order and
positions of I/O Units mounted, and not on fixed slot words. Special I/O Units
cannot be mounted to C200H Slave Racks controlled by a C500 Master; all
mounted Units will be assigned only one word each. The "type of Master"
switch an all C200H Slaves controlled by C500 Masters must be turned ON
to designate a Master other than the C200H Master.
C200H
C200H
Slave Rack
Slave Rack
C200H Slave
When C200H Slave Racks are connected to Masters on PCs other than the
C200H/C200HS, all Output Units on these Slave Racks will be treated as having
at least 16 output points. disabling the Fuse-burnout and Alarm Detection Bits on
Units that normally provide them (e.g., C200H-OD411, C200H-OD213,
C200H-OD214, and C200H-OA221).
When using the C200H Backplane for 10 slots as a remote I/O Slave for the
CVM1/CV500/CV1000/CV2000, only the 8 slots from the left can be used; the
9th and 10th slots from the left cannot be used.
Section 2-3
Slave Rack
Expansion I/O Rack
I/O Con-
necting
Cable
Expansion I/O Rack
Remote Interface
G7TC I/O
Block
Remote Terminal
Advertisement
Table of Contents
