Leckey MyWay+ Instructions For Use Manual page 38

p.38 MyWay+ User Manual
11.7 Saddle
• The saddle attaches into
into the dip in the plastic
moulding.
• Firstly, feed the pulley
straps through the
saddle. If this is not done
the straps will cause an
obstruction.
• Move the saddle upwards
so it is in a vertical position
and hook the saddle bar
into the dip in the plastic
moulding.
• Pull the lever outwards at
the end of the saddle and
move the saddle forwards
and upwards, continuing to
pull the lever outwards.
• Bring the saddle to it's final
position, then release the
lever. Check the saddle has
been securely connected
in at this stage. There is an
indicator to the side of the
saddle - if the indicator
shows green the saddle has
been connected securely;
if the indicator shows red
the saddle has not been
connected properly and this
must be done again.
• To detach the saddle,
pull the lever fully
outwards . Keep the lever
pulled out as you swing
the saddle downwards
and it detaches.
Warning – Use both hands when attaching/detaching the saddle.
Be aware of finger placement when attaching/detaching the saddle
to avoid potential for finger nipping.
Our recommended protocol is to perch the child on the saddle prior
to the harness being attached to the frame.
For users who have medical devices within/through the abdominal
wall e.g. Pegs, baclofen pump, it is recommend that the saddle is
kept in place during use. This reduces the likelihood of the harness
riding up and causing discomfort or injury.
The device's frame should be moved/controlled by placing hands
on the frame tubing or using the adult handles accessory only.
Do not attempt to move/control the frame using the upper support
unit or any other accessory.