Leckey MyWay+ Instructions For Use Manual page 19

p.19 MyWay+ User Manual
9.12 Upper Support Unit Adjustments | Overall Height Adjustment
• To adjust overall height
place your index finger on
the button and push up.
Then place your thumb
on the lever and press
down. The spine will then
move up and down - once
you have achieved the
desired position, release
the lever and button. Once
the button and lever are
triggered, you may need to
lift slightly upwards before
the spine will adjust.
9.13 Upper Support Unit Adjustments | Adjustment of the Harness Connection Points
• There is a button above each of
the pulley straps – each button
corresponds to the strap below
it. Each strap also corresponds to
the matching coloured buckles
i.e. the red strap corresponds to
the red buckles and the white
strap corresponds to the white
buckles. The straps control the
buckle positioning.
• To release the straps and buckles,
push one of the buttons
pull a corresponding buckle.
You only need to pull one side
to release both buckles of the
same colour . Then repeat the
process using the other button.
The straps and buckles are now
ready for the harness to be
attached to the frame.
Scan the QR code
with your phones
camera to view
and
Note – in order to operate
the overall height adjustment,
the fine height handles need
to be in their vertical, folded-
away position. Overall height
cannot be adjusted if these
handles are facing outwards
(horizontal).
Warning – do not
adjust overall height
whilst the user is in
the product.
Continued