Quick Start Guide - Sprout SOUNDWAVE LITE Product Manual

3.

QUICK START GUIDE

TURNING SOUNDWAVE LITE ON/OFF
To power on, long press the power button for 2
seconds. Soundwave Lite will announce "power on"
whilst the LED indicator light at the top will light up.
It will flash blue/red until a Bluetooth connection
has been established.
To power off, long press the power button for 2
seconds. The speaker will announce "power off"
with the LED indicator also turning off.
To preserve battery, Soundwave Lite will
automatically turn off after 5 minutes of no Bluetooth
or 3.5mm aux connection.
CONNECTING VIA 3.5MM AUX CABLE
To play audio using the aux cable, connect the cable
from the Soundwave Lite to your device. The LED
indicator light will change to a solid red. Soundwave Lite
will play the audio when you press 'play' on your device.
Please note: Using 3.5mm aux input will override a
Bluetooth source input.
4
3. QUICK START GUIDE
CONNECTING VIA BLUETOOTH
1. Press the power button for approximately two
seconds. The LED indicator light will flash blue and
red to indicate Soundwave Lite is ready for pairing.*
2. Turn on Bluetooth on your mobile phone/
music device.**
3. 'Soundwave Lite' will appear on your mobile
phone/music device. Select 'Soundwave Lite'
to pair.
4. Once your mobile phone/music device is
connected to the Soundwave Lite speaker,
the LED indicator light will change to a solid
blue, and the speaker will announce "Bluetooth
connected".***
5. Enjoy your music.
*Soundwave Lite will automatically enter Bluetooth pairing
mode when turned on for the first time. To reset Bluetooth
pairing, hold the UNISYNC button for 6 seconds to forget all
devices and initiate Bluetooth pairing mode again.
**If you are not familiar with Bluetooth pairing for your mobile
phone or music device, refer to the user guide for your mobile
phone/music device for instructions to pair a new device
using Bluetooth.
***Soundwave Lite will always store the last device paired
and if the device is within Bluetooth range, Soundwave Lite
will automatically connect to the device.
5