Advertisement
Advertisement
Related Manuals for Sprout Immerse
Summary of Contents for Sprout Immerse
- Page 1 INSTRUCTION MANUAL Immerse Bluetooth Speaker...
- Page 2 Sprout is proud to be an Australian owned brand. Starting small in 2011, we are now one of the largest single-branded accessory providers in Australia. We have an extensive range that highlights our pursuit of innovation across a growing number of technology categories.
-
Page 3: Table Of Contents
CONTENT 01. WHAT’S IN THE BOX? 02. PRODUCT OVERVIEW 03. QUICK START GUIDE 04. EXTRA CONTROLS 05. SPECIFICATIONS 06. IMPORTANT SAFETY INFO 07. CONSUMER GUARANTEE Scan the QR code to access an online version of this manual... -
Page 4: What's In The Box
What’s in the box? Thank you for choosing our Immerse Bluetooth Speaker. For optimum performance and safety, please read instructions carefully before usage. Please keep this manual for future reference. Immerse Bluetooth Speaker Australian standard charging adaptor power supply Aux-in audio cable... -
Page 5: Product Overview
Product Overview 1. Top control panel 9. Volume down button 2. Wireless charging pads 10. Play/Pause/Answer 3. Bluetooth button 11. Volume up button 4. Power button 12. Ventilation 5. UNISYNC button 13. USB Type-C 5V/2A output 6. LED indicator 14. Aux-in 7. -
Page 6: Quick Start Guide
1. Press power button for approximately three seconds, blue LED will turn on to indicate power is on. 2. Press Bluetooth button once, red and blue LEDs will flash to indicate Immerse is ready for pairing 3. Turn on Bluetooth on your mobile phone/ music device 4. - Page 8 Quick Start Guide - Buttons Power: Press the power button to turn the Immerse on or off. Play/Pause/Answer: Press the play/pause/answer button to play or pause songs and answer mobile phone calls. Volume control: Short press ‘-’ button to decrease volume.
-
Page 10: Extra Controls
Extra Controls UNISYNC mode If you are using the UNISYNC feature you can connect one Immerse as a primary, then connect up to 50 UNISYNC devices as replicas. To connect a replica, short press the UNISYNC button on your primary device once to enter UNISYNC Mode. - Page 11 LED indicator Solid blue LED indicates Immerse is switched on. Flashing: Flashing red and blue LEDs indicate Immerse is in pairing mode*. The battery LED indicator will flash from one to four LEDs to indicate Immerse is charging. The lights will stop flashing once Immerse is fully charged.
-
Page 12: Specifications
Specifications • Unit size: 299.16 x 173.98 x 122.80 mm (L x W x H) • Weight: 1.9kg • Output power: RMS 40W • S/N ratio: 85db +/- 3db • Frequency range: 90Hz - 20 kHz • Power source: 11.1V, 7800mAh lithium battery •... -
Page 14: Important Safety Info
4. Do not attempt to charge Immerse when it is wet, or you suspect water has seeped into Immerse. 5. Do not use Immerse near any open fire, heat source or excessive heat. 6. Do not open to modify, repair or remove any original component of Immerse. -
Page 15: Consumer Guarantee
For more information about your rights under Australia Consumer Law go to www.accc.gov.au. Your Immerse Bluetooth Speaker is warranted to the original owner for 24 months from the date of purchase against defects in material and workmanship under normal use and service. - Page 16 Sprout Accessories Pty Ltd Ph: 07 3624 6666 W: Sproutinc.com.au E: sproutenquiries@sproutinc.com.au...
Need help?
Do you have a question about the Immerse and is the answer not in the manual?
Questions and answers