Operating Controls - Sprout SOUNDWAVE LITE Product Manual

3. QUICK START GUIDE
CHARGING YOUR SOUNDWAVE LITE
1. Remove the port cover on the back of the speaker,
and connect the speaker via the USB-C port to the
USB-A power source, using the included charging
cable.
2. The LED battery indicator will flash from one to four
LEDs to indicate Soundwave Lite is charging. The
lights will stop flashing once Soundwave Lite is fully
charged. A full charge will take approximately
2-3 hours, depending on the speed of the charger.
Once charged, remove the charge cable and
replace the port cover.
Please note: Soundwave Lite will announce
"low battery" when the battery level reaches
approximately 10%.
LED BATTERY INDICATOR
4 white lights on: Battery 76-100%
3 white lights on: Battery 51-75%
2 white lights on: Battery 26-50%
1 white light on: Battery 0-25%
6
4.

OPERATING CONTROLS

LED INDICATOR
• Flashing blue/red - Bluetooth pairing mode
• Solid blue - Bluetooth connected
• Solid red - 3.5mm aux connected
POWER BUTTON
• 2 second long press - power on/power off
• 4 second long press - power on + Bluetooth pairing
PLAY BUTTON
• 1 press - play/pause/answer call/end call
• 2 second long press - reject call
• 2 presses - Siri/Google
VOLUME UP BUTTON
• 1 press - volume up
• 2 second long press - next track
VOLUME DOWN BUTTON
• 1 press - volume down
• 2 second long press - restart track
• 2 second long press x2 - previous track
UNISYNC BUTTON
TM
• 1 press - cycle through UNISYNC functions
(UNISYNC mode/UNISYNC audio/UNISYNC disabled)
• 2 second long press - disconnects Bluetooth
(device remains paired to Soundwave Lite)
• 6 second long press - resets UNISYNC and Bluetooth
connection (device will need to be re-paired)
7