Page 1
INSTRUCTION MANUAL Nomad Alpha Bluetooth Speaker...
Page 2
Sprout is proud to be an Australian owned brand. Starting small in 2011, we are now one of the largest single-branded accessory providers in Australia. We have an extensive range that highlights our pursuit of innovation across a growing number of technology categories.
CONTENT 01. WHAT’S IN THE BOX? 02. PRODUCT OVERVIEW 03. QUICK START GUIDE 04. EXTRA CONTROLS 05. SPECIFICATIONS 06. CARE AND MAINTENANCE 07. IMPORTANT SAFETY INFO 08. CONSUMER GUARANTEE Scan the QR code to access an online version of this manual...
What’s in the box? Thank you for choosing our Nomad Alpha Bluetooth Speaker. For optimum performance and safety, please read instructions carefully before usage. Please keep this manual for future reference. Nomad Alpha Bluetooth Speaker USB Type-A to USB Type-C charging cable...
Product Overview 1. Power button 9. Volume up 2. UNISYNC button 10. Locking side panel cap 3. LED flashlight 11. Aux-in 4. LED indicator 12. USB-A output 5. Battery LED indicator 13. Main power switch 6. Wireless charging pad 14. USB-C input 7.
Locking side panel cap 1. Place the cap over the input panel 2. Turn the cap clockwise until tight* *Nomad Alpha is only dust and waterproof when this cap is properly closed. Charging Nomad Alpha 1. Switch off the main power switch.
Page 7
Bluetooth. ***Nomad Alpha will always store the last device paired and if the device is within Bluetooth range, Nomad Alpha will automatically search & pair with the device.
Page 8
Long press ‘+’ button to select next song. Power: Press the power button to turn on or off. When turned off, Nomad Alpha remains in standby power mode. Please note that the main power switch at the side panel needs to be switched to on for the power button to operate.
Page 9
USB 2.0 output 5V/2.4A: To charge other devices with the Nomad Alpha, connect a USB Type-A cable into the Nomad Alpha USB 2.0 output 5V/2.4A, and plug the other end of the cable into your device. The main power switch must be in the ‘ON’...
Extra Controls UNISYNC mode If you are using the UNISYNC feature you can connect one Nomad Alpha as a primary, then connect up to 50 UNISYNC devices as replicas. To connect a replica, short press the UNISYNC button on your primary device once to enter UNISYNC Mode.
Page 11
When it is flashing red and blue LED light, Nomad Alpha is in pairing mode. The battery LED indicator will flash from one to four LEDs to indicate Nomad Alpha is charging. The lights will stop flashing once Nomad Alpha is fully charged. 4 blue lights on:...
Specifications • Unit size: 280 x 140.5 x 150.5 mm (L x W x H) • Weight: 2kg • Output power: RMS 40W • S/N ratio: 85db +/- 3db • Frequency range: 90Hz - 20 kHz • Power source: 11.1V, 15600mAh lithium battery •...
Close the side panel cap properly before use (see Locking side panel cap section). If Nomad Alpha is placed in water without the cap securely closed, water will enter Nomad Alpha and void the warranty.
Failure to do so may result in electrical shock, fire or electrical damage to Nomad Alpha and may void the warranty. 2. Do not use Nomad Alpha when you are charging the battery. 3. Do not use Nomad Alpha near any open fire, heat source or excessive heat.
For more information about your rights under Australia Consumer Law go to www.accc.gov.au. Your Nomad Alpha Bluetooth Speaker is warranted to the original owner for 24 months from the date of purchase against defects in material and workmanship under normal use and service.
Need help?
Do you have a question about the Nomad Alpha and is the answer not in the manual?
Questions and answers