Installing The Fixed Idler Pulley - Toro 78514 Operator's Manual

Figure 7
1. Lock nut, 3/8 inch
2. Washer, 7/16 inch
3. Spring loaded idler pulley
4. Washer, 13/32 inch
5. Long round spacer
6. Idler arm
7. Carriage bolt, 3/8 x 2 inch
8. Right rear bottom frame
9. Spring anchor
10. Flange nut, 3/8 inch
11. Bolt, 3/8 x 4–1/2 inch
12. Left rear bottom frame
Step
5
Installing the Fixed Idler
Pulley
Parts needed for this step:
1 Fixed idler pulley
1 Fixed idler bracket
1 Bolt, (3/8 x 1-1/2 inches)
2 Bolt, (3/8 x 3/4 inch)
1 Lock nut, (3/8 inch)
2 Flange nut, (3/8 inch)
1 Washer, 13/32 inch
Procedure
1. Install the fixed idler pulley to the fixed idler
bracket with a bolt (3/8 x 1-1/2 inches), washer
(13/32 inches), and a locknut (3/8 inch).
2. Install the fixed idler assembly to the left rear
bottom frame with 2 bolts (3/8 x 3/4 inch)
and 2 flange nuts (3/8 inch) (Figure 8).
Figure 8
1. Fixed idler pulley
2. Washer,
3. Nut,
4. Nut,
10
5. Bolt,
6. Fixed Idler pulley bracket
7. Left rear bottom frame
8. Bolt, 1/2 x 1-1/4 inch