Installing The Weights - Toro 78514 Operator's Manual

Figure 13
1. Drive pulley
2. Bagger pulley
3. Spring loaded idler pulley
2. If the gap is not correct, remove the spring.
3. To adjust the belt tension complete the
following:
A. Loosen the 2 nuts on the lower fan shaft
pillow block (Figure 14).
B. Insert a spacer behind the pillow block
(Figure 14).
C. Tighten the nuts.
D. Check the belt gap and repeat procedure
as required.
Figure 14
1. Pillow block
2. Fan shaft
4. Fixed idler pulley
5. Bagger belt
6. 1–1/8 inch ± 1/8 inch (29
mm ± 3 mm)
3. Spacer
Step
9

Installing the Weights

Parts needed for this step:
2 Caster weight
2 U-bolt
4 Nut, (1/2 inch)
4
Lock washer, (1/2 inch)
2 Plate
2
Small top weight
1 Large top weight
2 Bolt, 1/2 x 4 inch- for top weights
Procedure
To comply with ANSI/OPEI
B71.4-2004 Standard, top weights must be
added to the machine.
The bagger adds a lot of weight to the rear
of the machine and may cause an unstable
condition which could result in a loss of
control.
1. Place caster weights on the front casters.
2. Install plate, nuts (1/2 inch) and lock washer
(1/2 inch) under the frame and weight
(Figure 15).
3. Repeat for opposite side.
Note: Z Master mowers with 52 inch mower
decks require additional weight. Contact your
Authorized Service Dealer for the weight kit.
13