Installing The Bagger Mounting Brackets - Toro 78490 Operator's Manual

2
5
5
Figure 9
1. Bagger mounting bracket
2. Bolt, 5/16 x 1 in.
3. Flange nut, 5/16 in.
9. Using the bagger mounting bracket as a template, mark
the 4 hole locations in the center of the slots (Fig. 10).
10. Remove the bagger mounting bracket (Fig. 10).
11. Drill 4 pilot holes, 1/8 in. diameter, at the marked
locations. (Fig. 10).
12. Drill 2 holes, 13/32 in. diameter, into the side frame
through the 1/8 in. pilot holes. (Fig. 10).
13. Drill 2 holes, 13/32 in. diameter, into the side of the rear
bumper through the 1/8 in. pilot holes. (Fig. 10).
14. Repeat steps for the opposite side.
3
1
4
4
m–6099
4. Engine guard strap
5. Bumper
1
2
3
Figure 10
1. Bagger mounting bracket
2. Drill 13/32 in. hole
3. Rear bumper
Installing the Bagger Mounting
Brackets
Important
Do not tighten any bolts until both bagger
mounting brackets are fit loose on the machine.
Refer to Tightening the Mounting Bolts, on page 11, for the
correct procedure to tighten the bolts.
1. Install the bagger mounting bracket to the rear bumper
and side frame of the machine.
Note: Make sure to attach electrical relays, if needed.
2. Using the existing 1/4 in. hole in the side frame, loosely
install the bagger mounting bracket to the side frame
with 1 bolt (1/4 x 3/4 in.) and 1 flange nut (1/4 in.)
(Fig. 11).
3. Using the two holes drilled in the side frame, loosely
install the bagger mounting bracket to the side frame
with 2 carriage bolts (3/8 x 7/8 in.) and 2 flange nuts
(3/8 in.) (Fig. 11).
9
2
4
m–6021
4. Side frame
5. Existing 1/4 in. hole
5