Table of Contents
Advertisement
Operation
DMX Personality
DMX Control
Loss of Signal
Setting
Static Color
-10-
This setting allows you to choose a particular DMX personality.
1. Go to the PERS main level.
2. Select the desired personality (TOUR, TR16, FULL, ARC.1, AR1.D, ARC.2, AR2.D,
AR2.S, PIX1, PIX2, and HSV).
·
See the
DMX Values
personality.
·
Make sure that the starting addresses on the various products do not overlap due to
the new personality setting.
In this mode, each product will respond to a unique starting address from the DMX
controller. All products with the same starting address will respond in unison.
1. Select a DMX personality as shown in
2. Set the running mode:
a. Go to the RUN main level.
b. Select the DMX programming level.
3. Set the starting address:
a. Go to DMX main level.
b. Select the starting address (001–512).
The highest recommended starting address for each DMX mode are as follows:
DMX Mode
DMX Address
TOUR
503
ARC.1
510
AR1.D
509
PIX1
507
This setting controls how the product will respond when the DMX signal is lost.
1. Go to the SET main level.
2. Select DERR.
a. Select SAVE to make the product use the last command used when the signal is
lost.
b. Select BLAK to turn off the all the LEDs when the signal is lost.
The Static Color mode allows for permanent RGBW color mixing without a DMX controller.
1. Go to the STAT main level.
2. Select the desired color (RED, GREN, BLUE, or WHIT).
3. Select the desired color value (000–255).
4. Repeat for the other colors.
5. Select STRB.
6. Select the desired frequency (00–20).
section for the highest starting address you can select for each
DMX
Personality.
DMX Mode
DMX Address
ARC.2
AR2.D
AR2.S
PIX2
DMX Mode
509
HSV
TR16
508
507
FULL
505
COLORado™ 1-Quad IP User Manual Rev. 5
DMX Address
510
498
490
Advertisement
Table of Contents
