Tekno Point ATHENA C200 User And Installation Manual page 73

2. Use signal wire to connect every PCB CN16 to A-Serie board from master #1 to slave #N (N=total heat pump
quantity in the cascade). Connect the remote controller to RC in A-Serie board.
3. Set address by Dip-Switch as following form in every unit:
Dip switch
#1(master)
1 ON
2 OFF
3 OFF
4 OFF
4. After wiring connection, set the quantity of machines work in series by controller. In main menu, press
button for 3 seconds till there is a beep. Enter parameter b55 by pressing
or to set quantity of machines work in series. Press
5. Inquire parameters of machines work in series.
In main menu, press
, press button
check the parameters of that machine by control panel.
#2(slave) #3(slave)
OFF OFF
ON OFF
OFF ON
OFF OFF
button for 3 seconds till there is a beep. Enter parameter b56 by pressing
, press or to choose N° of machine. After choose N° of machine, you can
Unit address
#4(slave) #5(slave)
OFF ON
OFF OFF
OFF OFF
ON ON
to save the setting.
#6(slave) #7(slave)
OFF OFF
ON OFF
OFF ON
ON ON
or , press , press
or
73