Tekno Point ATHENA C200 User And Installation Manual page 48

The system must be installed following the current regulations relating to electrical systems and systems
with fluorinated gases.
The installation must be carried out in compliance with the requirements of IEC, NEC and CEC or equivalent
and exclusively by qualified personnel.
The air conditioner is the first class electrical equipment. It must be properly grounded with a dedicated
grounding device. The earthing system must have been built by professionals in compliance with current
regulations.
During installation, make sure that an earthing system exists and that the units are connected to earth
efficiently as electric shocks or electric shocks or malfunctions could occur.
The yellow-green cable identifies the grounding cable and must never be used for other purposes.
The earthing resistance must comply with current national electrical safety regulations.
The switch or the power plug of the unit must always be easy to log in by users at the conclusion.
All power and communication cables must be installed by qualified person. If the power cable is of
insufficient length, replace it with one of adequate length. Do not ever joints more cables.
In installations that do not include the power plug, a disconnector installed on the line and a must be
provided.
Moving the air conditioner from one place to another must only be carried out by qualified personnel in
order not to incur physical injury or damage the units.
Provide always places the installation of the units outside of the reach of children or pets. If it is not
possible to install the units in safe places, it is necessary to provide safety protection systems (protective
grids or similar) that prevent children or pets from coming into contact with the units.
Indoor units must be securely attached to the wall or ceiling. The block or ceiling to which they are
attached must be able to support the load generated by the units.
48