Warnings For The Installer - Tekno Point ATHENA C200 User And Installation Manual

During maintenance work, always disconnect the power supply to avoid electric shock or electric shock.
Do not wash the air conditioner with water to avoid damaging the electrical components.
Do not spray water on the indoor unit as it may cause damage to electrical components or malfunctions.
After removing the filter, do not touch the fins or fans to avoid injury.
Do not use flames or hair dryers to dry the filter (s) as they may be deformed or ignited.
Routine maintenance must be carried out by qualified personnel. Interventions unqualified personnel could
be cause physical injury to persons or damage to the units.
Repair work on the facility must necessarily be make the personnel qualified as you might incur electric
shock, electrocution or damage the unit. Please contact the service when it was necessary to repair the air
conditioner.
Do not insert fingers or objects into the air inlet or outlet to avoid injury or damage the units.
Do not block the air outlet or air inlet to the units in order not to generate malfunction or damage to them.
Never add water or soak in remote as it may damage.
If the following phenomena occur, it is necessary to turn off the air conditioner, immediately disconnect the
power supply and then immediately contact the installer:
• The power cord is overheated or damaged;
• Abnormal noises are detected during operation;
• There is a frequent intervention of the protection systems of the electrical system;
• The air conditioner produces a burning smell;
• The unit has a refrigerant gas leak.
If the air conditioner is operated in abnormal conditions, it can be damaged, malfunction, generate electric
shock or fire.
Operate the emergency start button on the indoor unit (where present) only with an electrically isolated
object and not on metal as it could cause electric shock.
Do not climb on or place heavy objects on the unit as the unit may break, damage or malfunction.

Warnings for the installer

The installation must be carried out exclusively by qualified professionals in order not to damage
or generate malfunction of the units or of the entire system.
During installation it is necessary to follow all the safety rules to electrical installations and to plants with gas.
need to follow the local safety standards and to provide for appropriate protection systems on power circuits
electric.
A magnetothermic switch of suitable size must be provided in order to protect the system from possible
overloads and short circuits.
At least one isolating switch of adequate size must be provided which sections each single phase and any
neutral cable. Or a removable and easily accessible power plug at the end of the installation.
The system must be connected securely to an adequate earthing system as the failure to connect could
cause shocks, electric shocks or generate malfunctions to the units.
Install adequate section power cables before using the system.
Use only certified power and communication cables.
Make sure that the power supply matches the requirements of the system to be installed. A power supply
of frequency and / or voltage different from the one foreseen or of unstable values, or incorrect wiring will
cause malfunctions to the system or damage to the units.
Connect to a system power supply terminal is the / the cable / s phase, that the eventual neutral cable that
the earthing cable.
Make sure always to have interrupted the power supply before carrying out any work related to electrical
connections and, in any event, follow always all the relevant safety procedures.
Do not power the system before the installation is complete.
If the power cord or communications cable is damaged no need to be replaced by qualified personnel.
Keep distance or use special insulation between the power cables and the communication and the piping of
gas because the high temperatures of the pipes could damage the cables.
47