Commissioning; Installing The Warewasher; Connecting The Warewasher; Water Connection - Miele PTD 701 Operating Instructions Manual

5

Commissioning

5.1

Installing the warewasher

The installation site must be frost-resistant to prevent the water supply systems from freezing.
Ø
Install the warewasher horizontally using a spirit level.
Ø
Adjust any unevenness of the base using the height-adjustable machine feet.
5.2

Connecting the warewasher

The warewasher and any other relevant additional devices must be connected in adherence to local standards and regulations by an
electrical company authorised by the relevant electricity supplier.

5.2.1 Water connection

The warewasher must be connected to the fresh water supply via the provided dirt trap, in order to achieve the water safety level pur-
suant to DIN EN 61770.
The dirt trap prevents particles from the inlet water from entering the warewasher, thus preventing extraneous rust on the cutlery and in
the warewasher.
Connecting the supply hose
Important notes:
– The supply hose must not be shortened or damaged.
– Only use the supply hose provided. Old, pre-existing supply hoses must not be re-used.
– Do not kink the supply hose when installing it.
Item Description
1 Inlet water connection PTD 701
2 Inlet water connection PTD 702, PTD 703, PTD 704
1
2
3
Operating instructions
1
1
2
Ø
Connect the supply hose (3) to the warewasher.
Ø
Connect the dirt trap (2) to the local water supply (1).
Ø
Connect the supply hose (3) to the dirt trap (2).
Ø
Open the water supply (1) and check that the connections are
sealed.
Ø
Connect the waste water hose (1) to the warewasher.
Ø
Guide and connect the waste water hose to the on-site waste
water connection.
| |
11208020/04; 2023-07
| |
Commissioning 5 English
55