Advertisement
ETC Installation Manual
QuickTouch+ Mk2 Control Panel and Electronics
Install in Back Box
Once you have terminated your control cables to the connectors provided, you can finish installing
the control panel and electronics in the previously installed back box.
Provide Strain Relief for Controls Cables
Ensure that you run your cables through the strain relief points on your control electronics.
Strain relief points for QT+ MK2 1CH controllers can be adjusted using a Phillips screwdriver.
Strain relief for QT+ MK2 6CH/12CH controllers require a 4 mm hex driver. Depending on how you
run your cables, you might angle the strain relief for the 6CH/12CH electronics, as shown in the
image above.
Connect Controls Cables to Electronics
Connect the 8-position clamp connectors to the appropriate terminals (MCX, E-stop) on the
electronics board. These are the connectors you terminated in the
QuickTouch+ Mk2 Control Panel and Electronics
QT+ MK2 1CH
Page 5 of 7
QT+ MK2 6CH/12CH
Terminate Wiring
section.
ETC
Advertisement
