Replacing The Presser Foot - ELNA eXcellence 792PRO Instruction Book

1.
(1)
2.
(3)
3.
(4)
4.

Replacing the Presser Foot

1. Raise the needle by pressing the needle up/down
(2)
2. Raise the presser foot lifter.
3. Press the black lever on the back of the foot holder.
4. Place the presser foot so that the pin on the foot lies
(7)
(6)
(5)
21
CAUTION:
Always make sure to press the lockout key to before
replacing the presser foot.
Use the proper foot for the selected pattern.
The wrong foot can cause the needle to break.
button.
Press the lockout key.
(1) Needle up/down button
(2) Lockout key
(3) Presser foot lifter
The presser foot will drop off.
(4) Lever
CAUTION:
To avoid damaging the lever, do not push it down.
just under the groove of the foot holder.
Lower the presser foot lifter to lock the foot in place.
(5) Pin
(6) Groove
Each foot is marked with an identification letter.
(7) Identification letter