Installation - HAMPTON BAY DSHD5979F Use And Care Manual

Installation

1
Preparing the fixture body
□
Unscrew the two mounting screws (3) from the fixture body (A).
□
Remove the fixture hood (2) and the EPE (1) from the fixture body
(A) and keep the fixture hood (2) and the two mounting screws (3)
for later use.
3
Making the electrical connections
□
Ground Wire:
□
Connect the fixture ground wire to the supply ground wire with a
wire connector (BB).
□
Supply Wire:
□
Connect the supply white wire to the white fixture supply wire
with a wire connector (BB).
□
Connect the supply black (or red) wire to the black fixture supply
wire with a wire connector (BB).
□
Wrap each connection with approved electrical tape and carefully
insert all of the connected wires into the post fitter of the fixture
body (A).
2
□
□
□
2
1
3
A
5
Preparing the fixture body
Carefully fit the post fitter of the fixture body (A) over
the end of the post (not supplied), making sure the post
fitter is fully seated.
Mark the drill point for the 3 mounting screws (AA)
using 3 mounting holes as reference.
After marking hole locations, remove fixture from post
and drill 1/16 in. pilot holes for screws.
Please contact 1-855-HD-HAMPTON for further assistance.
A
Post
A
BB
HAMPTONBAY.COM