Installation Instructions - HAMPTON BAY DYX1691A Instruction Manual

PARTS INCLUDED FOR INSTALLATION (parts are not to scale):
2ea Washers (#2) 2ea Lock Nuts (#3)
2ea Outlet Box Screws (#12)

INSTALLATION INSTRUCTIONS:

1. Screw the two Mounting Screws (#14) into the Cross Bar (#11). Mount the Cross Bar
(#11) to the Outlet Box (#9) using the two Outlet Box Screws (#12). [Make sure the
threads of the Mounting Screws (#14) are facing outside when the Cross Bar (#11) is
attached to the Outlet Box (#9).]
2. Wrap the ground wire from the fixture around the Ground Screw (#13) on the Cross
Bar (#11), and then connect the ground wire from the fixture to the ground wire from
the Outlet Box (#9). Connect the white wire from the fixture to the white wire
(neutral wire) from the Outlet Box (#9). Connect the black wire from the fixture to
the black wire (live wire) from the Outlet Box (#9). Cover the three connections
using the three Wire Connectors (#10). Wrap the three wire connections with
electrical tape for a more secure connection. Position the wires back inside the Outlet
Box (#9). Note: If you have electrical questions, consult your local electrical code
for approved grounding methods.
3. Place the fixture body to the wall by aligning the two protruding Mounting Screws
(#14) through the appropriate holes on the Wall Plate (#1). Place the two Washers (#2)
onto the two Mounting Screws (#14). Tighten the fixture to the wall by screwing the
two Lock Nuts (#3) onto the two protruding Mounting Screws (#14).
4. Once the fixture is mounted on the wall, caulk the space between the wall and the
upper 3/4 area of the Wall Plate (#1) to prevent water seeping into the Outlet Box
(#9). Leave the bottom 1/4 area uncaulked for drainage of any water which might
leak into the enclosure.
5. Installation is complete. Turn on the power at the circuit breaker or fuse box. Turn the
light switch on to activate the fixture.
Page 6
3ea Wire Connectors (#10)
1ea Ground Screw (#13)
1ea Cross Bar (#11)
2ea Mounting Screws (#14)