Advertisement
TRIP COMPUTER
GETTING TO
KNOW YOUR CAR
General information
The Trip computer is used to display information on
car operation when the key is turned to MAR-ON.
Two separate trips, called "Trip A" and "Trip B",
SAFETY
are provided to monitor the entire mission (journey)
in a reciprocally independent manner.
Both functions can be reset (reset - start of a new
STARTING AND
journey).
DRIVING
"Trip A" is used to display the figures relating to:
❒ Range
WARNING LIGHTS
❒ Distance covered
AND MESSAGES
❒ Average consumption
❒ Instantaneous consumption
❒ Average speed
IN AN EMERGENCY
❒ Trip time (driving time).
"Trip B" is used to display the figures relating to:
❒ Distance travelled B
SERVICING AND
MAINTENANCE
❒ Average consumption B
❒ Average speed B
❒ Trip time B (driving time).
TECHNICAL
SPECIFICATIONS
Note The "Trip B" function may be disabled (see
"Activating Trip B"). The "Range" and "Instant
consumption" parameters cannot be reset.
INDEX
28
Values displayed
Range
This indicates the approximate distance which can be
travelled with the amount of fuel present in the
tank. "- - - -" will appear on the display in the
following cases:
❒ range value lower than 50 km (or 30 mi)
❒ car parked with engine running for an extended
period.
IMPORTANT The range value variation can be
affected by several factors: driving style, type of route
(motorway, urban, mountain roads, etc.), conditions
of use (load, tyre pressures, etc.). Trip planning
must therefore take the above into account.
Distance covered
Shows the distance covered since the start of the
new journey.
Average consumption
Shows the approximate average fuel consumption
since the start of the new journey.
Instantaneous consumption
This indicates the fuel consumption. The value is
constantly updated. The display will show "- - - -" if
the car is parked with the engine running.
Advertisement
