Advertisement
❒ fit handle R fig. 127 to operate the jack and raise
the car until the wheel is a few centimetres above
GETTING TO KNOW
the ground;
YOUR CAR
❒ fully loosen the fastening bolts and remove the
wheel.
❒ make sure the contact surfaces between
SAFETY
space-saver wheel and hub are clean so that the
fastening bolts will not come loose;
❒ fit the space-saver wheel aligning the openings S
STARTING AND
fig. 128 with the corresponding centering pins T;
DRIVING
❒ using the wrench provided, tighten the four
fastening bolts;
❒ turn the jack handle R fig. 127 to lower the car and
WARNING LIGHTS
remove the jack;
AND MESSAGES
❒ use the wrench provided to fully tighten the bolts,
passing alternately from one bolt to the opposite
IN AN
one, as per the numerical sequence illustrated
in fig. 129.
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
fig. 128
166
REFITTING THE STANDARD WHEEL
Following the procedure described previously, raise
the car and remove the space-saver wheel.
Versions with steel rims
Proceed as follows:
❒ make sure the contact surfaces between standard
wheel and hub are clean so that the fastening
bolts will not come loose;
❒ fit the standard wheel aligning the openings S
fig. 128 with the corresponding centering pins T;
❒ using the wrench provided, tighten the fastening
bolts;
❒ lower the car and remove the jack;
❒ using the wrench provided, fully tighten the bolts
in the sequence shown in diagram fig. 129;
fig. 129
F0Q0396
F0Q0397
Advertisement
