RC22312A/RC32312A Evaluation Board Manual
1.3.3. Configure the Evaluation Board
1. To establish communication between the EVB and the GUI, click the Not Connected button in the lower right
corner, then click Connect.
2. Once the RICBox connection is established to the EVB, the "Not Connected" button will change to
"Connected".
3. Click the Program button to write all the changed registers from the GUI to the on-board device. Any register
changes made after clicking the "Program" button will occur in real-time and the device will update.
R31UH0022EU0100 Rev.1.00
Mar 28, 2023
Figure 30. Connect to the Device in RICBox
Figure 31. Connected Button
Figure 32. Program Button
Page 20