Table of Contents
Advertisement
Multi Zone—Continued
Setting the Multi Zone
1
Press the [RECEIVER] button
followed by the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn't appear, make
sure the appropriate external input is
selected on your TV.
2
Use the Up and Down [q]/[w]
buttons to select "7. Hardware
Setup", and then press [ENTER].
The "Hardware Setup" menu appears.
3
Use the Up and Down [q]/[w]
buttons to select "2. Multi Zone",
and then press [ENTER].
The "Multi Zone" menu appears.
4
Use the Up and Down [q]/[w]
buttons to select an item, and
use the Left and Right [e]/[r]
buttons to change it.
The items are explained below.
128
7. Hardware Setup
1. Remote ID
2. Multi Zone
3. Tuner
4. HDMI
5. Network
6. Firmware Update
7–2. Multi Zone
Zone2 Out
Fixed
Zone2 Maximum Volume
Off
Zone2 Power On Volume
Last
Zone2 Component Out
Use
Zone3 Out
Fixed
Zone3 Maximum Volume
Off
Zone3 Power On Volume
Last
5
When you've finished, press the
[SETUP] button.
The setup menu closes.
Note:
This procedure can also be performed on the AV control-
ler by using its [SETUP] button, arrow buttons, and
[ENTER] button.
■ Zone2/3 Out
If you've connected your Zone 2/3 speakers to an amp
with no volume control, set the "Zone2 Out" and "Zone3
Out" setting, respectively, to "Variable" so that you can
set the volume, balance, and tone of zone 2/3 on the AV
controller.
Fixed: The Zone 2/3 volume must be set on the
amp in that zone (default).
Variable: The Zone 2/3 volume can be set on the AV
controller.
■ Zone2/3 Maximum Volume
With this setting, you can limit the maximum volume for
Zone 2/3. When the "Volume Display" setting is set to
"Absolute", the "Maximum Volume" range is 50 to 99.
When it's set to "Relative", the range is –32 dB to
+17 dB. To disable this setting, select "Off".
■ Zone2/3 Power On Volume
This setting determines what the volume will be for
Zone 2/3 each time the AV controller is turned on.
When the "Volume Display" preference is set to "Abso-
lute", the range is "Last", "Min", 1 to 99, or "Max".
When it's set to "Relative", the range is "Last", –Q dB,
–81 dB to +18 dB.
To use the same volume level as when the AV controller
was last turned off, select "Last".
The "Zone2/3 Power On Volume" cannot be set higher
than the "Zone2/3 Maximum Volume" setting.
■ Zone2 Component Out
If you've connected the COMPONENT VIDEO ZONE
2 OUT to a TV in Zone 2, this setting is set to "Use".
Use: Select if a TV in Zone 2 is connected the
COMPONENT VIDEO ZONE 2 OUT.
Not Use: Select if no TV in Zone 2 is connected the
COMPONENT VIDEO ZONE 2 OUT.
Note:
If the "Zone2 Component Out" setting is set to "Not
Use", the same video signal as COMPONENT VIDEO
MONITOR OUT is output from ZONE2 OUT (compo-
nent).
Advertisement
Table of Contents
