Table of Contents
Advertisement
Advanced Setup—Continued
Miscellaneous (Volume/OSD) Setup
This section explains the items on the "Miscellaneous" menu.
1
Press the [RECEIVER] button followed by
the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn't appear, make sure the
appropriate external input is selected on your TV.
2
Use the Up and Down [q]/[w] buttons to
select "6. Miscellaneous", and then press
[ENTER].
The "Miscellaneous" menu appears.
6. Miscellaneous
1. Volume Setup
2. OSD Setup
3. 12V Trigger A Setup
4. 12V Trigger B Setup
5. 12V Trigger C Setup
Volume Setup
Volume Display
With this setting, you can choose how the volume level is displayed.
The absolute value 82 is equivalent to the relative value 0 dB.
Muting Level
This setting determines how much the output is muted when the muting function is used (page 64).
Maximum Volume
With this setting, you can limit the maximum volume.
To disable this setting, select "Off".
Power On Volume
With this preference, you can specify the volume setting to be used each time the AV controller is turned on.
To use the same volume level that was used when the AV controller was turned off, select "Last".
The "Power On Volume" cannot be set higher than the "Maximum Volume" setting.
Headphone Level
With this preference, you can specify the headphone volume relative to the main volume. This is useful if
there's a volume difference between your speakers and your headphones.
Absolute: Display range is "Min", 0.5 through 99.5, "Max".
Relative: Display range is –Q dB, –81.5 dB through +18.0 dB.
–Q dB (fully muted), –50 dB to –10 dB in 10 dB steps
Off, 50 to 99 (Absolute display)
Off, –32 dB to +17 dB (Relative display)
Last, Min, 1 to 99 or Max (Absolute display)
Last, –Q dB, –81 dB to +18 dB (Relative display)
–12 dB to +12 dB
3
Use the Up and Down [q]/[w] buttons to
select an item, and then press [ENTER].
The screen for that item appears.
4
Use the Up and Down [q]/[w] buttons to
select an item, and use the Left and Right
[e]/[r] buttons to change it.
The items are explained below.
5
When you've finished, press the [SETUP]
button.
The setup menu closes.
Note:
This procedure can also be performed on the AV control-
ler by using its [SETUP] button, arrow buttons, and
[ENTER] button.
105
Advertisement
Table of Contents
