Table of Contents
Advertisement
Advanced Setup—Continued
Lock Setup
With this preference, you can protect your settings by
locking the setup menus.
1
Press the [RECEIVER] button followed by
the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn't appear, make sure the
appropriate external input is selected on your TV.
2
Use the Up and Down [q]/[w] buttons to
select "9. Lock Setup", and then press
[ENTER].
The "Lock Setup" menu appears.
9. Lock Setup
Lock
3
Use the Left and Right [e]/[r] buttons to
select:
When the setup menus are locked, you cannot
change any setting.
Locked:
Setup menus locked.
Unlocked:
Setup menus not locked.
4
Press the [SETUP] button.
The setup menu closes.
Note:
This procedure can also be performed on the AV control-
ler by using its [SETUP] button, arrow buttons, and
[ENTER] button.
Digital Input Signal Formats
The digital input signal formats are available only for the
input sources that you have assigned a digital input jack
(see page 51).
Normally, the AV controller detects the signal format
automatically. However, if you experience either of the
following issues when playing PCM or DTS material,
you can manually set the signal format to PCM or DTS:
• If the beginnings of tracks from a PCM source are cut
• If noise is produced when fast forwarding or reversing
• The setting is stored individually for each input selec-
1
Unlocked
2
off, try setting the format to PCM.
a DTS CD, try setting the format to DTS.
tor.
Press the [RECEIVER] button, and then
press and hold [AUDIO] button for about
8 seconds.
While "Auto" is displayed (about 3 sec-
onds), press the Left and Right [e]/[r]
buttons to select: PCM, DTS or Auto.
PCM:
Only 2-channel PCM format input signals will be
heard. If the input signal is not PCM, the PCM
indicator will flash and noise may also be pro-
duced.
DTS:
Only DTS (but not DTS-HD) format input sig-
nals will be heard. If the input signal is not DTS,
the DTS indicator will flash and there will be no
sound.
Auto (default):
The format is detected automatically. If no digital
input signal is present, the corresponding analog
input is used instead.
111
Advertisement
Table of Contents
