Lock Setup; Using The Audio Settings - Onkyo PR-SC5508 Instruction Manual

Auto Power Down
■
Auto Power Down
Off:
Auto Power Down disabled.
On:
Auto Power Down enabled.
When "Auto Power Down" is set to "On", AV controller
will automatically perform STANDBY operation if there
is no operation for 30 minutes with no audio and no video
signal input.
"Auto Power Down" will display on the display and OSD
from 30 seconds before the Auto Power Down functions.
Default setting: On (European and Asian models), Off
(North American models)
Note
• Depending on some sources, the auto power-down function may
activate during playback.
• The Auto Power Down function does not work when Zone 2 or
Zone 3 is on.
Network
See "Network Settings"
Firmware Update
See "Firmware Update" for update procedure
Note
• Perform the firmware update only when an announcement is
posted on the Onkyo web site. See the Onkyo web site for latest
information.
• It takes about 60 minutes to complete the firmware update.
• When updating a firmware from a USB mass storage device, the
AV controller searches the device which is connected earlier dur-
ing power on. If two devices have been connected at the time of
power on, the AV controller will search the device on the front
panel.
■
Version
The current version of the firmware is displayed.
■
Receiver
via NET:
You can update the firmware via Internet. Check the
network connection before update.
via USB:
You can update the firmware from a USB mass stor-
age device.
You can update the AV controller's firmware. Do not shut-
down the power of the AV controller while update.
■
Universal Port
via NET:
You can update the firmware via Internet. Check the
network connection before update.
via USB:
You can update the firmware from a USB mass stor-
age device.
You can update the Onkyo dock's firmware. Do not shut-
down the power of the AV controller while update.
En
62
(➔ 71).
(➔ 104).
Note
• This update shall not be performed when no dock is connected
to UNIVERSAL PORT jack.

Lock Setup

With this preference, you can protect your settings by
locking the setup menus.
Main menu Lock Setup
■
Setup
Locked:
Setup menus locked.
Unlocked:
Setup menus not locked.
When the setup menus are locked, you cannot change any
setting.

Using the Audio Settings

You can change various audio settings from the Home
menu (➔ 27).
1
Press RECEIVER followed by HOME.
2
Use q/w to select "Audio", and then use q/w/e/r
to make the desired selection.
Note
• These settings are disabled when the "Audio TV Out" setting is
set to "On" (➔ 60) and an input selector other than HDMI is
selected.
Tone Control Settings
You can adjust the bass for the front, front wide, front
high, center, surround, surround back and subwoofer
speakers and treble for the front, front wide, front high,
center, surround and surround back speakers, except when
the Direct, Pure Audio or THX listening mode is selected.
■
Bass
–10dB to 0dB to +10dB in 2 dB steps.
You can boost or cut low-frequency sounds output.
■
Treble
–10dB to 0dB to +10dB in 2 dB steps.
You can boost or cut high-frequency sounds output.
Operating on the AV controller
1
Press TONE on the AV controller repeatedly to
select either "Bass" or "Treble".
2
Use Up r and Down e on the AV controller to
adjust.
Note
• This setting is not available when the multichannel analog input
is selected.
• To bypass the bass and treble tone circuits, select the Direct, Pure
Audio or THX listening mode.