Table of Contents
Advertisement
User's Manual
Monitoring mode (MONITOR): 1 to 8 ports support port priority, optimize port cache, switch all ports
can communicate with each other.
Network extend mode(EXTEND): 1 to 8 port rate down to 10 Mbps, the farthest transmission distance
of up to 250 meters, all ports can communicate with each other.
10/100 Mbps RJ-45 ports (1 to 24):
Designed to connect to the device with a bandwidth of 10 Mbps, 100 Mbps. Each has a corresponding
Link/Act and PoE indicator.
10/100/1000Mbps RJ-45 port 25:
Designed to connect to the device with a bandwidth of 10 Mbps, 100 Mbps or 1000 Mbps. Each has a
corresponding Link/Act LED.
1000Mbps SFP port 25:
Designed to install the SFP module. The Switch features one SFP transceiver slots that are shared with
one associated RJ-45 ports. A SFP port and an associated RJ-45 port are referred to as "Combo" port,
which means they cannot be used simultaneously, and only SFP port work or only RJ-45 port work at
the same time.
1.3.2 Rear Panel
The rear panel of the Switch contains one Grounding Terminal, Heat vent and AC power connector
shown as below.
Rear panel
Grounding Terminal:
Located on the left side of the power supply connector, use wire grounding to lightning protection.
Heat vent:
The Heat vent is located in the middle position of the rear panel of the switch. It is used for heat
dissipation and ventilation. Do not cover it.
AC Power Connector :
Power is supplied through an external AC power adapter. It supports 100–240 VAC, 50/60 Hz.
Package Contents
Before installing the Switch, make sure that the following the "packing list" listed OK. If any part is lost
and damaged, please contact your local agent immediately. In addition, make sure that you have the
tools install switches and cables by your hands.
One 24-Port 10/100 Mbps + 1-Port Gigabit Combo Base-T SFP multi-mode PoE Switch.
3
Advertisement
Table of Contents
