Dahua DH-PFS3125-24ET-190 User Manual page 8

LED indicators:
The LED Indicators will allow you to monitor, diagnose and troubleshoot any potential problem with
the Switch, connection or attached devices.
The following chart shows the LED indicators of the Switch along with explanation of each indicator.
Faceplate
LED Indicator
Marker
Power Indicator PWR
MAX indicator PoE MAX
10/100 BASE-T
adaptive Ethernet
Link
port indicators (1-
24, 25)
PoE status
indicators
PoE
(1-24)
Mode Control:
You can select the switch mode.
Normal mode (NORMAL): Switch all ports can communicate with each other
Port isolation mode (VLAN): 1 to 24 cannot communicate with each other, but can communicate with
the uplink Combo port 17.
Front panel
LED indicator
Table 1-1 Description of the indicator
Status Indication
Off Power Off
Solid green Power On
Off PoE load value is normal
The PoE load value reaches the set limit value
Solid red which is 190 W, and the load quota can no longer
be increased.
Off The port is NOT connected.
The port is connected, but no data is
Solid green
transmitting or receiving.
Blinking The port is transmitting or receiving data.
No PD is connected to the corresponding port,
Off
or there is a breakdown.
A Powered Device is connected to the port,
Solid yellow
which supply power successfully.
2
User's Manual