Table of Contents
Advertisement
3. After you connect to the clock, the SFTP client displays the above or a similar window. The green frame
points to the correct directory in the clock. In the red frame, navigate to the directory on your PC where
the new firmware is located. This file will be displayed in the orange window. Then drag-and-drop the
file to the pane that the orange arrow points to. Then the new firmware will be uploaded to the clock.
4. Once the upload is complete, turn off the clock.
5. Wait 10 seconds.
6. Turn the clock on again. The clock will show the firmware version and the progress bar, as usual.
7. At the end of the startup sequence, the dot matrix display will show the following messages in order:
Figure 39: Upload the new firmware
FW UPGRADE
Unpack
Verify
67
Kronos Series 3
Advertisement
Table of Contents
