Out-Of-Bound Limits (Offline); Table 27: Gps Receiver Settings - Novatech Kronos 2 Series User Manual

Table of Contents

Advertisement

Parameter
Description
[GNSS]
GPS related parameters are defined in section [GPS].
ANT_DELAY
Value (in nanoseconds) that corresponds to the delay introduced by the antenna
cable, typically 1.2ns/ft (4ns/m). The exact delay can be computed by:
where
Default: 60ns (equivalent to 50ft (15m) antenna cable)
GALILEO
Use of these satellite systems can be enabled if desired by setting the respective
value to TRUE. GLONASS and BeiDou cannot be enabled at the same time. Note
GLONASS
that GPS is always enabled. The default value for each is FALSE.
BEIDOU
FAKE_GNSS
If TRUE, antenna connection and reception of satellite signals is simulated by the
unit.
Note: The time reported by the clock will not be correct if FAKE_GPS is TRUE.
Make sure to set FAKE_GPS to FALSE before normal operation. Alternatively,
delete or comment out the line from the configuration file.
FAKE_TIME
If a date and time are entered, the clock uses and displays the entered date and
time and counts up time from there instead of using the satellite signal. This is
useful for testing.
Example: 2023-01-01 12:00
Note: The time reported by the clock will not be correct if date and time are
entered for FAKE_TIME. Make sure to remove date and time for normal
operation. Alternatively, delete or comment out the line from the
configuration file.

5.11 Out-of-bound Limits (Offline)

The parameters in this section configure the user defined out-of-bounds limits. All values are in
milliseconds. Valid values are from 0.001ms (1 microsecond) to 4000ms (4 seconds). See section
States
for an explanation of how these limits affect clock operation. The same settings can be made in the
webpage as described in
GNSS Settings
# User defined out-of-bounds limits (in miliseconds)
# Valid values are from 0.001 (1 microsecond) to 4000 (4 seconds)
[LIMITS]
LOWQUALITY = 2
BADTIME = 500
8
c = 3 x 10
m/s is the light speed
K
is the velocity factor of the cable being used
v
l is the cable length in meters.
K
is 0.82 for the Aircell 5 cable and 0.85 for the Ecoflex 10 Plus cable. For
v
other cables, refer to the corresponding datasheet.

Table 27: GPS receiver settings

(Online).
47
Kronos Series 3
Clock

Advertisement

Table of Contents
loading

Related Products for Novatech Kronos 2 Series

This manual is also suitable for:

Kronos 3 series

Table of Contents