Ph Set Up - CLEAN Instruments PH200 Operation Manual

5.3 pH Set Up
5.3.1 PO1 pH Standard Solution
USA SALE
4.01 6.86 9.18
É 250" % buF 401 7.00 1001
i E
d 685 © ro: OY
e * — büF * — büF
E
E ni Sk GAL
dI
Les
Les
* After power-up, the unit will enter the measurement mode. Factory default is pH measuring
mode. You can switch between the pH measurement mode and the ORP measurement mode
by pressing the Key.
* Press © to enter SET up step; Press to enter the Electrode Calibration mode.
e |n P-01, you can select a group of buffer solutions as a standard: USA (4.01, 7.00, 10.01) or NIST
(4.01, 6.86, 9.18).
* Please refer to above description steps to set up P-01.
e You can go to next parameter setting by pressing © , Or pressing key to quit and
go back to measurement mode.
Factory default: USA
Note:
1. During setting, you can press key to quit setting whenever necessary.
2. During setting, you can adjust anything twinkling by pressing (2) ©) If it is the data twinkling,
you can speedy adjust the data by pressing
08