Po1 Cell Constant (K) - CLEAN Instruments PH200 Operation Manual

Q
O
Z
N
(=
o
Q
O
=
e
o
o
6.3 Set Up
6.3.1 PO1 Cell Constant (k)
IA SEN o» SEN
E "©
%
GEN
(D
SHU
s8 O
pos
Yme
E3
Ca
le
SAUE
SEN
"SAY
CI *
EI
le
| SEN & GEN
"SAL
eo eo &
EI
le
The unit will enter into measurement mode after power on. Factory default is Conductivity
measurement mode. Press to switch between Conductivity measurement mode and Total
Dissolved Solids measurement mode. Press to enter into parameter setting mode. Press
to enter into electrode calibration mode.
In P-01, you can set up cell constant k of your sensor for measurement application.
e Please refer to above description steps to set up P-01.
* You can go to next parameter setting by pressing È , Or press key to quit and go
* back to measurement mode.
Measurement range:
Cell constant k= 1.0, For Middle range;
Cell constant k- 10, For Wide range (More than 40 mS/cm or 10ppt);
Cell constant k=0.1, For Middle range (Below 40 us/cm or 10ppm);
Cell constant k=0.01, For Middle range (Below 10 us/cm) ;
Factory default: Cell constant k=1.0.
Note:
1. During setting, you can press key to quit setting whenever necessary.
2. During setting, you can adjust anything twinkling by pressing O . If it is the data
twinkling, you can speedy adjust the data by pressing 9 ;
22