Po7 Reverting To Factory Default Setting - CLEAN Instruments PH200 Operation Manual

5.3.7 P07 Reverting to Factory Default Setting
$ dEF
mm
{LI
=
& JEF
dEF dEF
% %
dE 3 LLP
e
O
LO)
-L
Qu
==
e
[e]
N
-L
Qu
* After entering P-07, you can select NO or YES to not reverting or reverting to factory settings by
pressing A . If select YES, the meter will revert all the settings to factory defaults and all
the settings will lost forever. The unit will restart at the same time.
* Please refer to above description steps to set up P-07.
* You can go to next parameter setting by pressing È , Ot pressing key to quit and
go back to measurement mode.
Note:
1. During setting, you can press key to quit setting whenever necessary.
2. During setting, you can adjust anything twinkling by pressing © . If it is the data
twinkling, you can speedy adjust the data by pressing 9 ;
13