Table of Contents
Advertisement
7.3 Set Up
7.3.1 PO] Atmospheric Pressure
In measurement mode, press
to switch between Saturation Percentage and Oxygen
concentration mg/L. Press
to enter into parameter setting mode.Press
To enter into
electrode calibration mode.
In P-01, you can adjust Atmospheric Pressure value for compensation to get the better measure-
ment result.
Please refer to above description steps to set up P-01.
Range: 600mbar-1400mbar.
You can go to next parameter setting by pressing A
, OF press
key to quit and go
back to measurement mode.
Note:
1. During setting, you can press
key to quit setting whenever necessary.
2. During setting, you can adjust anything twinkling by pressing È
. If it is the data
twinkling, you can speedy adjust the data by pressing A
.
o
©
Te)
Q
Q
=>
o
o
q
Q
e
33
Advertisement
Table of Contents
Need help?
Do you have a question about the PH200 and is the answer not in the manual?