Indicators During Sending/Receiving Operation; Responding To An Attention Indicator Flashes - Olivetti System 12 Operation Manual

Troubleshooting > Indicators During Sending/Receiving Operation

Indicators During Sending/Receiving Operation

The [Data] ( ) indicator show the fax transmission status.
• The [Data] ( ) indicator blinks during fax transmission and reception.
• The [Data] ( ) indicator is lit when there is source data stored in the memory for delayed transmission.

Responding to an Attention Indicator Flashes

If the [Attention] ( ) indicator flashes, select the [Status/Job Cancel] key to check an error message. If the message
is not indicated on the touch panel when the [Status/Job Cancel] key is pressed or the attention indicator flashes, check
the following.
Symptom
Cannot send fax.
Checkpoints
Is the modular cord
connected correctly?
Is Permitted FAX No. or
Permitted ID No. registered
correctly?
Has a communication error
occurred?
Is the destination FAX line
busy?
Does the destination FAX
machine respond?
Is there an error other than
above?
11-2
Corrective Actions
Connect the modular cord correctly.
Check Permitted FAX No. and
Permitted ID No.
Check error codes in the TX/RX
Result Report and Activity Report. If
the error code starts with "U" or "E",
perform the corresponding
procedure.
Send again.
Send again.
Contact your Service
Representative.
Reference
Page
—
8-15
11-6
—
—
—