Table of Contents
Advertisement
Chapter 2
Installation
This chapter covers the physical installation of the Gigaset Gateway.
Minimum System Requirements
• DSL service and an Internet access account from an Internet Service Provider (ISP).
• Network cables for each device you intend to connect to the Gateway.
• TCP/IP network protocol must be installed on all computers.
• For USB connection to the Gateway, the following operating systems are supported:
•
Windows 98, 98SE
•
Windows 2000
•
Windows ME or XP
•
Mac OS versions 8.6 through 10.2.4
Note: Your configuration may vary slightly from the instructions and illustrations in this chapter. Refer to
your service provider's documentation, or contact them with questions regarding your specific
configuration.
Hardware Installation
You may position the Gigaset Gateway at any convenient location in your office or home. No special
wiring or cooling requirements are needed; however, you should comply with the safety guidelines
specified in the
General Safety Guidelines
Basic Installation Procedure
1.
Install line filters if
necessary.
2.
Connect the
cables.
3.
Install USB drivers if
4.
Configure network settings on your
5.
Configure the Gateway via the Web-based management
6. Reboot the computer if prompted. Whenever you are required to reboot the Gateway, allow five
seconds between turning off the unit and powering it back on.
section.
necessary.
computer.
interface.
6
2
Advertisement
Table of Contents
