Flyback Timing (Lap Timing); Example: Recording A Race Lap Time - Casio Edifice EQB-1200D-2AER Operation Manual

Flyback Timing (Lap Timing)

Hours, minutes Seconds
Hours (24-hour time)
1.
In the Calendar Mode, press (A).
Navigating Between Modes
l
This enters the Stopwatch Mode and
starts an elapsed time measurement
operation.
Each press of (B) causes the elapsed time
of the section (lap time) to be shown for
about 10 seconds.
A
Timing Start 1
B
Timing Start 2
B
Timing Start 3
A
Stop
Elapsed time measurement for the next
●
lap continues internally during the
approximately 10 seconds that the lap
time is shown.
When the elapsed time exceeds 10
seconds, the hands will return to
indicating the current lap time.
Pressing (B) when the next lap time is
10 seconds or less will display that lap
time.
2.
Press (B) to reset the elapsed time to all
zeros.
To return to the Calendar Mode, reset
●
the stopwatch to all zeros and then
press (B).
Watch Operation Guide 5666
Lap Times
●
A lap time is the time elapsed during a specific
lap or segment. Lap times are recorded
internally by the watch. The watch displays the
elapsed time of the current lap.
Note
Lap times can be viewed with EDIFICE
●
Connected after measurement is
complete.
Viewing Stopwatch Data
l
A
Start
Lap Time 1
B
Lap Time 2
B
Lap Time 3
A
Goal
Example: Recording a Race
Lap Time
This section explains how to record lap times
while watching a race. It also shows how you
can view lap times with EDIFICE Connected
after the race is over.
Lap Times
l
During a race
Measure lap times.
1.
In the Calendar Mode, press (A).
Navigating Between Modes
l
This enters the Stopwatch Mode and
starts an elapsed time measurement
operation.
2.
Use the operations below to perform a
timer operation.
A
Timing Start 1
B
Timing Start 2
B
Timing Start 3
A
Stop
Pressing (B) at the end of each lap will
record them in watch memory.
Lap times are recorded in 1/1000-
●
second units during the first hour of an
elapsed time measurement operation.
3.
Press (B) to reset the elapsed time to all
zeros.
To return to the Calendar Mode, reset
●
the stopwatch to all zeros and then
press (B).
After a race
After the race is finished, you can view the
measured lap times with EDIFICE Connected.
Sending Stopwatch Data to a Phone
l
Checking a Lap Time
l
17