Using the Crown
Fast Forward/Fast Reverse
●
Crown
Normal timekeeping
Second click
First click
Important!
To prevent loss of water resistance
●
and/or damage due to impact, be sure
to push the crown in to its normal
position after you are finished using it.
When pushing the crown back in, take
●
care not to apply too much force.
After pulling out the crown to the first or second
click, rotating it quickly in succession in either
direction will start a fast forward or fast reverse
operation. While a fast forward operation is in
progress, quickly rotating the crown in
succession again will increase the speed even
further.
Stopping Fast Forward/Fast Reverse
●
Rotate the crown in the direction opposite that
of the ongoing operation or press any button.
Note
If you do not perform any operation for
●
about two minutes after pulling out the
crown, crown operations will
automatically become disabled. If that
happens, push the crown back in and
then pull it out again.
Watch Operation Guide 5666
Hand and Day Indicator
Movement
Function Hand and Day Indicator
●
Movement
Changing the day setting of the watch will also
cause the function hand to move.
Day
●
It can take anywhere from about 50 seconds
●
to about 3 minutes and 20 seconds for the
day indicator to change after timekeeping
reaches midnight. At this time, the function
hand moves as the day indicator changes.
The day may not be indicated correctly
●
while the watch's crown is pulled out.
Day indicator
Function hand
Charging
This watch runs on power supplied from a
rechargeable (secondary) battery that is
charged by a solar panel. The solar panel is
integrated into the face of the watch, and
power is generated whenever the face is
exposed to light.
Charging the Watch
●
When you are not wearing the watch, put it in
a location where it is exposed to bright light.
While you are wearing the watch, make sure
that its face (solar panel) is not blocked from
light by the sleeve of your clothing. Power
generation efficiency is reduced even when
the face of the watch is blocked only partially.
YES
NO
Important!
Depending on light intensity and local
●
conditions, the watch may become hot
to the touch when exposed to light for
charging. Take care to avoid burn
injury after charging. Also, avoid
charging the watch under high-
temperature conditions like the ones
described below.
On the dashboard of a vehicle
ー
parked in the sun
Near an incandescent light bulb or
ー
other source of heat
Under direct sunlight or in other hot
ー
areas for long periods
8