Table of Contents
Advertisement
Checking the Difference
Between the Current and
Previous Lap Times
You can check the difference between the
previous and current lap times while a lap time
measurement operation is in progress.
Using This Function
Pressing (B) displays the difference between
the current and previous lap times.
A
Timing Start 1
Lap Time 1
B
Timing Start 2
Lap Time 2
B
Timing Start 3
Lap Time 3
B
Timing Start 4
A
Stop
When you measure a lap time, the function
●
hand indicates the difference between the
current and previous lap times.
From measurement of the second lap time,
●
you can check the difference between the
current and previous lap times.
To determine the difference between the
current and previous lap times
Same as previous lap time
1 second
fast
5 seconds
fast
5+ seconds
fast
Target time indicator
Watch Operation Guide 5666
The watch will beep when an alarm time is
reached.
The alarm sound is muted in the cases
●
described below.
When battery power is low
ー
When the watch is at Level 2 power
ー
saving
Power Saving
l
Using EDIFICE Connected to
Configure Alarm Settings
If the watch is paired with a phone, you can
also use EDIFICE Connected to set alarms.
Setting the Alarm
l
1 second
slow
2+ seconds
slow
Alarm
Configuring Alarm Settings
1.
Pull out the crown to the first click.
This causes the second hand to move to
12 o'clock, and the function hand to move
to [DT].
Function hand
2.
Press (A).
This causes the function hand to move to
[ALM] and turns on the alarm.
3.
Rotate the crown to change the alarm time
setting.
Check the 24-hour hand to see if it is
●
indicating a.m. or p.m. for the alarm
time.
Alarm on
4.
Push the crown back in.
To stop the alarm
●
To stop the alarm after it starts to sound when
an alarm time is reached, press any button.
Note
A beeper sounds for 10 seconds when
●
an alarm time is reached.
Crown
Minutes
Hours
＋
−
Crown
18
Advertisement
Table of Contents
