Timing the First and Second
Place Finishers
1.
Enter the Stopwatch Mode.
Navigating Between Modes
l
2.
Use the operations below to measure
elapsed time.
D
Start
A
1st Finisher*
D
2nd Finisher*
* This displays the time of the first
finisher.
Elapsed time is shown in 1/100-second
●
units for the first hour of the
measurement. After the first hour,
elapsed time is shown in one-second
units.
First hour
After first hour
Minutes, seconds,
Hour, minute, second
1/100 seconds
3.
Press (A) to display the time of the second
finisher.
4.
Press (A) to reset the measurement time
to all zeros.
Watch Operation Guide 3542
The timer counts down from a start time
specified by you. A beeper sounds when the
end of the countdown is reached.
The beeper is muted when battery power is
●
low.
Using CASIO WATCHES to
Configure Timer Settings
If the watch is paired with a phone, you can
also use the CASIO WATCHES phone app to
set the timer start time.
Configuring Watch Settings
l
Setting the Countdown Start
Time
The countdown start time can be set in 1-
second units up to 24 hours.
If a timer countdown operation is in
●
progress, reset the timer to its current start
time before performing this operation.
Using the Timer
l
1.
Enter the Timer Mode.
Navigating Between Modes
l
2.
Hold down (A) for at least two seconds.
This causes the hours digits to flash.
3.
Use (B) and (D) to change the timer hours
setting.
Holding down (B) or (D) scrolls through
●
settings at high speed.
Timer
Hours
4.
Press (C).
This causes the minutes digits to flash.
Minutes
5.
Use (B) and (D) to change the timer
minutes setting.
6.
Press (C).
This causes the seconds digits to flash.
Seconds
7.
Use (B) and (D) to change the seconds
setting.
8.
Press (A) to exit the setting screen.
Note
While the setting is being configured,
●
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Setting a start time of [0:00 00] will
●
perform a countdown of 24 hours.
25