Auto Time Adjustment - Casio 5690 Operation Manual

4. Y
Perform the operation shown on the
screen of the phone to be paired with.
When a connection is established
between the watch and phone, [CNCT]
will stop flashing.
If pairing fails for some reason, [ERR]
●
will appear on the display momentarily
and then the watch will return to the
Timekeeping Mode. Perform the pairing
procedure again from the beginning.
Pairing started. Pairing complete.
Note
The first time you start up CASIO
●
WATCHES phone app, a message will
appear on your phone asking if you
want to enable location information
acquisition. Configure settings to allow
background use of location
information.
Watch Operation Guide 5690

Auto Time Adjustment

Your watch will connect with a phone at preset
times each day and adjust its time settings
automatically.
Using This Function
●
Your watch adjusts its time setting four times
a day according to a preset schedule. If you
leave your watch in the Timekeeping Mode, it
will perform the adjustment operation
automatically as you go about your daily life,
without any operation required by you.
Important!
The watch may not be able to perform
●
auto time adjustment under the
conditions described below.
While the watch is too far away from
ー
its paired phone
While communication is not possible
ー
due to radio interference, etc.
While the phone is updating its
ー
system
While the CASIO WATCHES phone
ー
app is not running on the phone
Note
If the watch does not indicate the
●
correct time even if is able to connect
with a phone, adjust the hand
positions.
Adjusting Hand Alignment
l
If there is a World Time City specified
●
with the CASIO WATCHES phone
app, its time will also be adjusted
automatically.
The watch will connect with the phone
●
and perform auto time adjustment at
around 12:30 a.m., 6:30 a.m., 12:30
p.m. and 6:30 p.m. The connection is
automatically terminated after auto
time adjustment is complete.
Triggering Immediate Time Adjustment
●
The watch's time setting will be adjusted
automatically whenever you establish a
connection between the watch and a phone.
Whenever you want to trigger immediate time
adjustment, perform the procedure below to
connect with a phone.
1. X
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Move the phone close to (within one meter
of) the watch.
3. X
Press (D).
[TIME] flashes to indicate that the watch
has started the connection operation.
Once the watch and phone are
connected, [OK] will appear, and then the
watch will adjust its time setting based on
information from the phone.
At this time your current location is
●
recorded by your phone.
Trying to connect
Note
The connection is terminated
●
automatically after time adjustment is
complete.
If time adjustment fails for some
●
reason, [ERR] will appear.
[RCVD] flashes when the receive
●
operation starts, and [RCVD] stops
flashing after it is complete.
After time
adjustment
9