Table of Contents
Advertisement
Installing the Filter Tube and the
Divider Tube
1.
Prepare the hydraulic-filter tube retained from
Removing the Cross Tube (page
tube nut for the hydraulic-filter tube to the fitting
in the cross-manifold tube as shown in
10.
Figure 10
1. Divider tube (flow-divider
fitting)
2. Hydraulic-filter tube (filter
base fitting)
3. Flow-divider manifold
4. Cross-manifold tube
2.
Thread the tube nut for the hydraulic-filter tube
onto the fitting in the cross-manifold tube, and
tighten the nut to 51 to 63 N∙m (37 to 47 ft-lb).
3.
Align the tube nuts for the divider tube to the
fittings in the cross-manifold tube and the
flow-divider manifold
4.
Thread the tube nuts for the divider tube onto
the fittings in the cross-manifold tube and the
flow-divider manifold, and tighten the nuts to 37
to 45 N∙m (27 to 33 ft-lb).
4). Align the
Figure
5. Divider tube
(cross-manifold tube
fitting)
6. Hydraulic-filter tube
(cross-manifold tube
fitting)
7. Forward
(Figure
10).
Installing the Traction-Motor Tube
1.
Align the tube nuts for the traction-motor tube
to the fittings in the traction motor and the
flow-divider manifold
1. Traction motor
2. T-fitting
3. Traction-motor tube
(traction-motor fitting)
2.
Thread the tube nuts for the traction-motor tube
onto the fittings in the traction motor and the
flow-divider manifold, and tighten the nuts to 116
g205017
to 142 N∙m (85 to 105 ft-lb).
9
(Figure
11).
Figure 11
4. Traction-motor tube
(flow-divider fitting)
5. Flow-divider manifold
6. Forward
g205018
Advertisement
Table of Contents
