Toro 31527 Installation Instructions Manual page 14

Figure 21
1. Hex locknut
2. Washer (15/32 inch)
g274109
3. Hex locknut
4. Toggle switch
7
Installing the Wire Harness
to the Machine
4WD Switch Only
Parts needed for this procedure:
1 Wire harness
1 Relay
1 Self-tapping screw
Procedure
Important:
This procedure is necessary if you
install the 4WD switch.
1. Route the wire harness along the existing
harness into the opening in the frame behind the
seat (Figure 22).
Toolbox shell removed for clarity
1. Entrance into right toolbox
2. Opening in frame
3. New wire harness
2. Secure the new wire harness, in the console, to
the existing wire harness.
3. Route the terminal plug and the eyelet
connection into the right toolbox
14
Figure 22
4. Existing wire harness
5. Rear of right console
(Figure
g205030
23).