Table of Contents
Advertisement
4
Installing the Hydraulic
Components
Parts needed for this procedure:
1
Flow-divider manifold
1
Pressure hose
1
Manifold tube
1
Traction-motor tube
1
Divider tube
1
Tank hose
2
Bolt
2
Flange nut
Installing the Flow-Divider
Manifold
1.
Align the holes in the flow-divider manifold with
the holes in the chassis bracket.
Note:
Ensure that the 45° fitting is pointing
down and toward the back of the machine.
Bottom View Shown
1. Front, right tire
2. Flange nuts
3. Chassis bracket
2.
Secure the flow-divider manifold to the chassis
bracket with the 2 bolts and 2 flange nuts.
Tighten the bolts to 37 to 45 N∙m (27 to 33 ft-lb).
Figure 6
4. Coils (for use with 4WD
switch only)
5. Flow-divider manifold
6. Bolts
Installing the Rear-Traction Tube
and the Pressure Hose
1.
Align the forward tube nut for the rear-traction
tube with the elbow fitting in the flow-divider
manifold
1. Traction-motor tube
2. Divider tube
3. Hydraulic-filter tube
4. Rear-traction manifold
5. Cross-manifold tube
6. Pressure hose
2.
Thread the forward tube nut onto the elbow, and
tighten the nut to 51 to 63 N∙m (37 to 47 ft-lb).
g205001
7
(Figure 7
and
Figure
8).
Figure 7
7. Hydraulic pump
8. Rear-traction tube
9. Flow-divider manifold
10. Traction motor
11. Forward
g205002
Advertisement
Table of Contents
