Toro 31527 Installation Instructions Manual page 5

Removing the Tube Bracket and
Clamp
1. Remove the bolt and the nut that secure the
divider tube to the tube bracket, and remove the
clamp (Figure 3 or
2. Remove the 2 bolts and the 2 nuts that secure
the tube bracket to the chassis bracket
or Figure 2).
Note:
Discard the tube bracket, clamp, and
hardware.
Removing the Divider Tube
1. Remove the tube nut for the rear-traction tube
from the fitting of the divider tube.
2. Remove the tube nut of the divider tube from
the T-fitting in the front-left traction motor, and
remove the tube from the machine
Figure 3).
Note:
Discard the divider tube.
3. If you are installing the 4WD switch, continue
this procedure. If you are not installing the
4WD switch, skip to
Components (page
Figure 2).
(Figure 3
(Figure 2
4 Installing the Hydraulic
7).
Removing the Tank Hose
Important:
This procedure is necessary if you
install the 4WD switch.
1. Align a drain pan below the forward, straight end
of the tank hose.
2. Remove the forward end of the tank hose from
the fitting in the hydraulic fluid tank, cap the
fitting on the tank, and allow the hydraulic fluid
to drain from the hose.
or
1. Hydraulic-tank fitting
2. Tank hose
3. Remove the rear, angled end of the tank hose
from the bulkhead fitting and remove the tank
hose.
4. Temporarily cap the bulkhead fitting.
Note:
Discard the original tank hose.
5
Figure 4
Bottom View
3. Bulkhead fitting
g205311